Discover our Clipsal Smart Home packages as seen on the Block

in location

OR

I'm looking for

  • Wholesalers
    • Uncheck All Check All
  • EXPERTISE
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All
OR

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    How do you set up the ATV61 drive to be used with the VW3A3314 Apogee P1 option card?

    Issue:
    How do you set up the ATV61 drive to be used with the VW3A3314 Apogee P1 option card?

    Product Line:
    Altivar ATV61 with VW3A3314 option card.

    Environment:
    All

    Cause:
    Needs setup assistance with the ATV61 and Apogee P1 card.

    Resolution:
    Card connector Pin outs

    Contact B= (+) signal
    Contact A= (-) signal
    Contact GND= (GND)
    Contact SCR= (Shield)

    Programming Drive  ( You must Power cycle after changing any of the Menu 1.9 coms parameter settings)
    Menu 1.9- Communications (CON)
    Address range is 0-99  (Choose your address)
    Baud rate: Choose between 4800 to 76800
    Network time out = range is 2 to 60 seconds (Choose your network time out)

    Menu 1.6 Command menu
    Controlling the drive over the network
    Ref 1 = Com card
    Profile is Not separate
    Point # 24 (LDO  table) is your start command for CMD  (writing a 1 will start 0 will stop)
    Point # 60 (LAO table) is your input speed reference 1 in %
    Note: If the drive will not start with writing a 1 to Point #24 try writing a 0 to #24 1st then writing a 1.

    Reading data only from the drive.
    Ref 1 AI1
    Profile not separate
    Point #03= freq output in hz
    Point #05= speed output in rpms
    Point # 06= Motor current
    Point # 07= Motor Torque
    Point # 08= Motor Power
    Point # 09 = Drive Temp
    There are other values that you can read in the LAI table see the attached document for information.

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance