Discover our Clipsal Smart Home packages as seen on the Block

in location

OR

I'm looking for

  • Wholesalers
    • Uncheck All Check All
  • EXPERTISE
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All
OR

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    Using a double delta configured generator on split-phase XW series inverters

    Some three-phase generators have two sets of independent output windings per phase which can be reconfigured in several different ways. These types of generators are sometimes referred to as '12-wire' generators as there are 6 windings/coils with 2 wires each.

    The wiring on these types of generators can be configured in a method known as 'double-delta', which will provide single/split-phase phase power, with each leg 180 degrees out of phase. This should work with split-phase XW series inverters. A sample phasor diagram of a 12-wire generator in double delta is shown below. Please refer to the generator manufacturer for detailed documentation for a specific generator. Note that 3-phase generators which only have one set of windings (sometimes called 4 or 6 wire generators) cannot be configured in this manner and cannot work with a split-phase XW inverter system. 
     

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance