Discover our Clipsal Smart Home packages as seen on The Block 2018

in location


I'm looking for

  • Wholesalers
    • Uncheck All Check All
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    How do I connect the AGS to my HoneyWell HW7000EH?

    This particular Generator does not have a remote connection. If approved by HoneyWell, we can piggyback to the switch panel wires and simulate the connection using the AGS' relays. 
    - Generator Type: Type 8

    - Wires Needed on AGS Harnes:

    13,14,16, 17, 18

      * Wires 13, 16, 18 get connected together

    - Wire 14 goes to the "Black" wire that     connects to the Ignition Coil

    - Wire 17 gets connected to the "Black / White" cables that controls the Starter Motor

    - Wire 13, 16 & 18 go connected to the "White" wire that connects to the battery positive of the unit (+12VDC)

    Wiring diagram found page 13 on link:

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance