Discover our Clipsal Smart Home packages as seen on the Block

in location

OR

I'm looking for

  • Wholesalers
    • Uncheck All Check All
  • EXPERTISE
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All
OR

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    What is the pin-out of the RJ45 socket of an ATV31 / 312 for connection of Modbus, CanOpen and PowerSuite cables

         The RJ45 socket of the ATV31/312 can be used for connection to the following networks and accessories:


         a PLC via a Modbus bus or via a CANopen network
         a PC/laptop loaded with PowerSuite software
         The VW3A31101 remote display terminal

         The Pin out of the RJ45 socket of the ATV31 is as follows:


         Pin no.                            ATV31 RJ45                         Comments          
         RJ45
     

            1                                       CAN high                           CAN-H - Signal for CANopen communication 
     
            2                                       CAN low                             CAN-L - Signal for CANopen communication 
     
            3                                       CAN GND                          CAN-GND - Signal for CANopen communication 
     
            4                                           D_B                               Signal for MODBUS communication 
     
            5                                           D_A                                Signal for MODBUS communication 
     
            6                                            NC                                 Not used 
     
            7                                          10 Volts                           0-10 V voltage supplied by the ATV31/312 which can be used to supply the 

            8                                           0 Volts                            converter when connected using PowerSuite software  

        Important clarification
     

       
       For Modbus communication, the signals used for the ATV31 /312 are D-B and D-A only -  the other connections are not used.

       For CANopen communication, the signals used for the ATV31 / 312 are CAN-H, CAN-L and CAN-GND -  the other connections are not used.

       With the VW3A31101/ VW3A1006/7remote display terminal, the signals used are D-B and D-A as well as the power supply.

      Caution: Lengths of cables need to be observed as too greater voltage drop in network connections may cause a malfunction.

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance