Discover our Clipsal Smart Home packages as seen on the Block

in location

OR

I'm looking for

  • Wholesalers
    • Uncheck All Check All
  • EXPERTISE
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All
OR

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    Wiser Power Meter will not connect to Coordinator

    Issue:
    Wiser Power Meter will not connect to Coordinator.  Home Owner entered the catch phrase of Power Meter, but the device will not add the network.

    Product Line:
    Wiser Home Management System,  EER21200, WISERJLPM200

    Environment:
    Wiser Home Management System,  wiserernergy.com

    Cause:
    This issue can be caused by several factors.  The most common cause found in 2014, state of Texas, KB Homes, was that the contractors install the Power Meter in metal boxes on the outside of the house.  The metal box blocks the ZigBee radio signal.

    Resolution: 
    Some locations, such as Texas, it is common to install a Utility Meter / Circuit Breaker Combo panel on the outside of the house.   If the breaker panel is on the outside of the house, then the Power Meter is probably on the outside of the house as well.  Find out the condition of the Power Meter installation.  If the Power Meter is in a metal box, then test joining to the network with the cover the of the metal box removed.   If this works, then the metal box is the cause.   The first recommended action is to force the installing contractor to install the Power Meter in a plastic or fiberglass enclosure.   Another solution is to install the Coordinator or another Wiser Device very close to the Power Meter but on the inside of the house.  If the distance is short enough, the devices might be able to communicate even though the Power Meter is in a metal enclosure.  

    Verify that the breaker feeding power to the Power Meter is on.  Verify that the Power Meter indicator lights work properly and that and the Power Meter is in join mode.  

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance