Discover our Clipsal Smart Home packages as seen on the Block

in location

OR

I'm looking for

  • Wholesalers
    • Uncheck All Check All
  • EXPERTISE
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All
OR

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    Why don't Xanbus devices show up on my Combox web page?

    Make sure Xanbus LED is lit on Combox. If not, remove network cable from Xanbus port on Combox and measure across the outer pins of the network cables for 12VDC (XW Inv/Chg and MPPT80 should supply 12VDC to network when active with battery power).

    Xanbus cable should have 12VDC across the two outer pins, or one of the following are true:

    1)  Cat5 cable is bad.
    2)  XW Inv/Chg or MPPT80 is not supplying network power. This may be because the battery voltage is too low, or the network circuit is defective.

    NOTE : If 12VDC is verified across outer pins of network cable, but Combox Xanbus LED is still not lit, restore Combox to factory defaults.

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance