Discover our Clipsal Smart Home packages as seen on The Block 2018

in location

OR

I'm looking for

  • Wholesalers
    • Uncheck All Check All
  • EXPERTISE
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All
OR

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    Connecting Meter Directly to Computer via a RJ-45 Ethernet Cable

    Issue 
    The user wants to connect directly to a PowerLogic Meter via a RJ-45 crossover cable

    Product Line 
    PowerLogic Meters with Ethernet Option and EGX Gateways

    Environment
    Windows OS, Command Prompt

    Resolution
    This article outlines the procedure for connecting a PowerLogic Meter directly to a computer via an ethernet cable. A cross-over ethernet cable is required for this task. 

    1. Obtain a RJ-45 Ethernet CROSS-OVER cable.
    2. Connect one end of the cable to the Meter and Computer to the other.
    3. Assign an IP address and Subnet Mask to the meter (see Example below) ignoring the gateway settings
    4. Assign an IP address and Subnet Mask to the computer :

    • Go to Start -> Settings -> Control Panel -> Network and Sharing Center -> Change adapter settings
    • Right-Click on the Local Area Connection and choose Properties
    • Scroll down and select Internet Protocol Version 4 (TCP/IP) and click Properties
    • Use the screenshot and information shown below as a reference to assign IP address and subnet masks to the computer and meter
                                  

    • Enter an IP Address and Subnet Mask. Assign the same subnet mask as on the meter and ensure the IP Address is on the same subnet as the meter (See Example below)
    • Example of IP assignment :
      Meter:
      IP Address: 10.168.68.1
      Subnet Mask: 255.255.255.0

      Computer
      IP Address: 10.168.68.10
      Subnet Mask: 255.255.255.0
    • Save the Local area connection properties by clicking ok
    5. Test comms by pinging the meter for a response in the Command Prompt (CMD)
    6. Use ION Setup, Power Monitoring expert or Modbus Tester to connect to meter.


     

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance