Discover our Clipsal Smart Home packages as seen on The Block 2018

in location

OR

I'm looking for

  • Wholesalers
    • Uncheck All Check All
  • EXPERTISE
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All
OR

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    How to check and see which addresses have been used in a ProWORX NxT project?

    Goals and Symptoms

    To see which addresses have been used in a ProWORX NxT project.

    Causes and Fixes

    With your ProWORX NxT project open, click on Display then Used table. This will open the Address Used window. Click on the Rebuild Used button to update the addresses used.
    Below are the different types of information you can display in the table:

    Logic Only: When selected, the table displays information as follows:
    x - Address used in logic.
    u - Coil used in logic.
    . - Unused address.
    c - Coil duplicated in logic.

    Traffic Cop: When selected, the table displays information as follows:
    x - Address used in logic.
    u - Coil used in logic.
    . - Unused address.
    T - Address used in the Traffic Cop and logic.
    U - Address used in the Traffic Cop, in logic, and as an output coil.
    t - Address only used in the Traffic Cop.

    Peer Cop: When selected, the table displays information as follows:
    u - Coil used in logic.
    x - Address used in logic.
    . - Unused address.
    P - Address used in the Peer Cop and logic.
    U - Address used in the Peer Cop, in logic, and as an output coil.
    p - Address only used in the Peer Cop.

    I/O Scanner: When selected, the table displays information as follows:
    u - Coil used in logic.
    x - Address used in logic.
    . - Unused address.
    D - Address used in the I/O Scanner and logic.
    U - Address used in the I/O Scanner, in logic, and as an output coil.
    d - Address only used in I/O Scanner.

    All: When selected, the table displays information as follows:
    x - Address used in logic.
    u - Coil used in logic.
    . - Unused address.
    D - Address used in the I/O Scanner and logic.
    d - Address only used in I/O Scanner.
    P - Address used in the Peer Cop and logic.
    p - Address only used in the Peer Cop.
    T - Address used in the Traffic Cop and logic.
    t - Address only used in the Traffic Cop.
    U - Coil used in three or more different locations.
    M - Address used in three or more different locations.

    To view an address type, click the corresponding tab.....0xxxx, 1xxxx, 3xxxx or 4xxxx.

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance