Discover our Clipsal Smart Home packages as seen on The Block 2018

in location


I'm looking for

  • Wholesalers
    • Uncheck All Check All
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    Adding the 170ADM85010 and 170ADO83030 I/O bases to the module pick list in Concept.

    Goals and Symptoms

    The purpose of this resolution is to illustrate the steps necessary to add the 170ADM85010 and 170ADO83030 I/O bases.

    Causes and Fixes

    The attached MDC files will be needed to add these modules. Put the MDC files in the Concept root directory and remove the .txt file extension.
    Once this is done, launch the ModConnect Tool from the Programs menu as seen below:
    Once the ModConnect tool is running, Choose "Open Installation File"
    Choose the appropriate MDC file from the window shown below:
    The next window will allow the user to choose which modules are added. Choose "Add All"
    The tool will then show the added modules:
    The tool can be closed. When Concept is launched, these bases will be available from the pick list for Momentum bases.

    NOTE: This procedure must be done on every computer where the project will be used. If it is not done on a computer where the project is used, the Momentum controller will not run the project and will come up with a 4000h error code.

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance