Discover our Clipsal Smart Home packages as seen on the Block

in location

OR

I'm looking for

  • Wholesalers
    • Uncheck All Check All
  • EXPERTISE
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All
OR

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    Assigning an IP address to a brand new Twido TWDLCAE40DRF processor using the Concept Ethernet configurator tool and TwidoSuite.

    Goals and Symptoms:

    Assigning an IP address to a brand new Twido TWDLCAE40DRF processor using the Concept Ethernet configurator tool and TwidoSuite.

    Causes and Fixes:


    Assigning an IP address to a brand new Twido TWDLCAE40DRF processor using the Concept Ethernet configurator tool and TwidoSuite.



    On Power up of the new un-configured controller the L ST LED will be flashing 5 times.

    • 1) Set the IP address of your PC to the same IP scheme as the address that is being assigned to the new controller.
      (ex. 192.168.30.xxx, 255.255.255.000)
      2) Must be logged on as administrator and disable antivirus software, firewalls, wireless connection.
      3) Connect directly between your PCs NIC card and the new controller with a crossover cable.


    Launch the Concept Ethernet configurator tool.


    Select the Add button.


    Enter the last octet of the new IP address as the Node followed by the new controllers MAC address and then press the OK button.


    Verify that all the info entered is correct.


    Press the BootP server button to turn on the tool and within about 15 seconds the status will change to assigned and the L ST LED on the controller will go on solid.


    The L ST LED on the controller will go on solid.



    Press the BootP server one more time to turn off the tool.


    Open a DOS command prompt and make sure that you can ping the new assigned IP address.


    Launch TwidoSuite.

    Select the Programming Mode button.



    Select the correct operation.


    Open the project that you want to configure, change and or download into the new controller.


    Select the Program tab followed by the Debug tab then press the Manage connection button at the bottom.
    Now press the Add button and enter the new IP address info followed by the Apply button.



    In order to complete your IP information configuration for your project you must do the following:
    • 1) Select the Describe tab
      2) Right click on the RJ45 port and select Configuration


    Enter information as shown in the example above and press the OK button.


    Save current project changes.


    Select the OK button.

    Select Transfer PC controller.
    Select the OK button.

    Press OK to stop controller if needed.

    Press OK to overwrite previous application if needed.



    Ethcfg.zip

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance