Discover our Clipsal Smart Home packages as seen on the Block

in location


I'm looking for

  • Wholesalers
    • Uncheck All Check All
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    What can we do if we have OBF or OCF fault on ATV58 while we use the braking resistor ?

    What can we do if we have OBF or OCF fault on ATV58 while we use the breaking resistor ?
    Product Line:
    OBF or OCF 


    OCF-Overcurrent Faut:
    Recheck all the motor parameters.
    Monitor the output current to see if it is drawing more than the FLA of the motor.

    OBF-:Overbraking Fault:

    The ObF fault occurs when the DC bus voltage spikes up over 840VDC.  If the drive is telling the motor to stop but the fan is being pushed by other fans, could be regenerating energy back onto the bus of the drive.  Have customer to monitor the DC bus voltage on the + and - terminals.
    Measure the line voltage and compare to the displayed line voltage (Uln, in the display menu).
    Measure the DC Bus voltage (Should be square root of 2 times the input line voltage).
    Increase the DEC parameter (Adjustment menu).
    Set the BrA parameter (drC menu) to yes. This allows the deceleration ramp to be automatically increased to avoid overbraking fault.  The BrA should be set to no, if using a braking resistor.
    Check the Braking Resistor

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance