Discover our Clipsal Smart Home packages as seen on The Block 2018

in location

OR

I'm looking for

  • Wholesalers
    • Uncheck All Check All
  • EXPERTISE
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All
OR

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    What are the causes of the Trip Circuit Fault or CB Control Fault on a SEPAM relay and how may it be cleared?

    Issue
    A trip circuit fault is displayed on the front face of the SEPAM.

    Product Line      
    SEPAM 20, 40, 50, 80

    Environment    
    SEPAM programming

    Cause
    The trip circuit fault on a SEPAM relay is caused by:
    1. Circuit breaker control is enabled but the contacts I11 and I12 are not connected, or are connected incorrectly.
    2. Circuit breaker control is enabled but the contacts I11 and I12 don't transfer within 200ms.
    3. Circuit breaker control is disable but contacts I11 and I12 are assigned to the open and closed status from the breaker.
    Note: If SEPAM 80 Series is being used I11 = I101 and I12 = I102.



    Resolution
    To correct the issue, connect to the relay using SFT2841 then:
    Case 1. Wire the breaker status contacts to I11 and I12 or wire these contacts correctly.
    Case 2. Go to the program logic screen in SFT2841 and reassign I11 and I12 to either customized use if they are being used, or to not used if the contacts are not wired

    Note: Until the fault has been cleared, the relay will continue to show the Trip Circuit Fault on the front display.
    To clear the fault from the front display, do the following:
    1. Press the Alarm button.
    2. Press the Enter key.
    3. Press the Clear button to clear the fault.

    To clear the fault using SFT2841, do the following:
    1. Connect to the relay
    2. Click the Alarm button
    3. Click the Reset button

     

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance