Discover our Clipsal Smart Home packages as seen on The Block 2018

in location


I'm looking for

  • Wholesalers
    • Uncheck All Check All
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    What is the function of an SDX switch?

    What is the function of the SDX relay module for Powerpact H J and L circuit breakers?

    Product Line:
    Circuit Breakers

    Powerpact H, J, and L circuit breakers with advanced Micrologic trip units

    Circuit breakers equipped with Micrologic 3, 5, and 6 trip units can take the optional SDx Module.
    The SDx Module receives data from the trip unit through a fiber optic link.

    Default alarms are as follows
    • Micrologic 5 trip unit:
    — Output 1 is the thermal fault indication (SDT).
    — Output 2 is the long-time pre-alarm (PAL Ir).
    • Micrologic 6 trip unit:
    — Output 1 is the thermal fault indication (SDT) for electrical distribution applications.
    — Output 1 is None for motor-feeder applications.
    — Output 2 is the ground-fault indication (SDG).
    • For Micrologic 3 trip units, the SDx is nonconfigurable and indicates thermal trip alarm

    • For Micrologic 5 and 6, SDx can be configured for different alarms.
    Note that the SDX can be used for ground fault alarm on non configurable 6 (LSIG) trip units, but it will not provide ground fault alarm on a Micrologic 5 (LSI) trip unit.  Therfore, GF alarm without tripping is not possible.
    All alarms on a trip, failure, and maintenance event and all alarms associated with a measurement previously activated in the Alarms tab can be assigned to an SDx Module output.
     For complete list, refer to Alarms section of  manual 48940-312-01.
    To set alarms, access the SDx Module output settings using the RSU software under the Output tab.

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance