Discover our Clipsal Smart Home packages as seen on The Block 2018

in location


I'm looking for

  • Wholesalers
    • Uncheck All Check All
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    How many leak sensor cables can be attached in series on an 600 mm unit

    How many leak sensor cables can be attached in series on an 600 mm unit

    Product line:
    All InRow 600 mm units

    All Serials


    Install up to four optional leak sensors (AP9326) as needed. 1. Connect the leak sensor to the equipment using the plug located as shown.

    Position the leak sensor inside or outside the equipment.




    Route the leak sensor to the outside of the equipment through either the bottom plate or the door.


    Secure the leak sensor wire to surfaces using cable ties and cable tie holders (provided with the leak detector).








    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance