Discover our Clipsal Smart Home packages as seen on The Block 2018

in location


I'm looking for

  • Wholesalers
    • Uncheck All Check All
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    Video: Programming the ATV312 for terminal start stop & speed control via the VW3A1101 remote keypad display or the local dial on the front of the drive.

    How can you set up the ATV312 drive to start and stop with terminal control and use the VW3A1101 remote keypad as speed control or the knob on the drive?  

    Product line:
    Altivar ATV312 

    All models, all serial numbers 

    Starting and stopping the drive with +24v and LI1 FWD and using the remote keypad's knob (or the knob on the front of the drive) as speed control. 

    Hold the MOD button until you see the 3 LEDs on the left of the drive's display start scrolling (flash in sequence).
    The drive is now in local mode. You can not do any programming in this mode. 
    Now you will need to hold the ESC button for 3 seconds unit you see the same LED's now flash all together at the same time.
    The drive is now in local/ programming mode. 
    Push the enter (press the dial once). 
    Scroll down (turn the dial clockwise) to the CTL menu and press enter
    Scroll down to LAC and press enter
    Set LAC to L3 or level 3 (you must hold enter for 3 seconds for the change to save), press ESC
    Scroll down to FR1
    Set FR1 to A1U1 
    Scroll down to CHCF 
    Set CHCF to SEP 
    Scroll down to CD1 
    Set CD1 to tEr for terminal control 
    Once you are done programming, press the ESC button several times, until the drive displays rdy.
    Next you will need to put the drive back in Local run mode by holding the ESC button again for 3 seconds until you see the 3 LED's scroll.
    Now you can start the drive in 2 wire control by closing LI1 to +24vdc and use the remote HMIs dial for speed control. 

    This procedure also sets up the drive to adjust the speed from the dial or knob on the front of the drive if the remote keypad is not used.

    Refer to the ATV312 programming manual for additional details.  Link here:

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance