Discover our Clipsal Smart Home packages as seen on the Block

in location

OR

I'm looking for

  • Wholesalers
    • Uncheck All Check All
  • EXPERTISE
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All
OR

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    ATV61 programming assistance with the water solutions card VW3A3503.

    Issue:  
    Programming and wiring up a water solution card on the ATV61 drives?

    Product line:
    Altivar ATV61 with water solutions option card VW3A3503.

    Environment:
    All models, all serial numbers 

    Cause:
    Water Solution Card set up configuration.

    Resolution:
    First, go through the Pre-Configuration section in the manual.   Transducer is 0-145 PSI with 4-20mA Output. There are 2 additional External pumps.   Go to Page 86 to set System Units =1 (Imp, Gallon and Degree Fahrenheit)   Water Solutions/Expansion/PID PID Ref Local (Local PID reference will appear under Water Solutions menu) PID Max Ref 100 psi PID Feedback  Drive AI2 PID Gain 50 PID Integral 1   Water Solutions/Expansion/Sensors Outlet Transducer Maximum   145 psi Pressure Units PSI   Water Solutions/Expansion/Start Set Setpoint Ramp  5.0   Water Solutions/Expansion/Stage Number of External Pumps 1 Stage Speed  50 hZ  Jumper: +24 to CI_LI54 External Pump 1 No Fault +24 to CI_LI55 External Pump 2 No Fault +24 to CI_LI57      Auto enable   The Feedback Pressure(monitored under water Solution menu) must be lower than the Start Pressure(programmed in Start Set) when closing CI_LI57 and want the unit to start.
     
    Wiring examples:
    CLI57= auto enable or start
    CLI58= fault reset

    Transducer input
    AI2= Analog input on the drive
    AI52 and AI51= analog inputs on the water solutions card

    Fault feedback inputs from aux pump overload relays
    CLI54= for fault input for Aux pumpt 1
    CLI55= for fault input for Aux pumpt 2
    CLI56= for fault input for Aux pumpt 3

    Aux pump outputs
    CLO51= Aux output for pump 1
    CLO52= Aux output for pump 2
    CLO53= Aux output for pump 3

    Status outputs from the WSC
    CLO55= Run status
    CLO56= Fault status

    Jockey pump option
    CLO56= Jockey or priming pump output

    Programming manual VW3A3503

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance