Discover our Clipsal Smart Home packages as seen on the Block

in location

OR

I'm looking for

  • Wholesalers
    • Uncheck All Check All
  • EXPERTISE
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All
OR

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    Video: How to configure redundant group control for a DG4 or DG5 controller

    Issue:
    How to configure redundant group control for a dg4 or dg5 controller

    Product line:
    Carel DG4 DG5

    Environment:
    All Product models, all serial numbers

    Cause:
    Install

    Resolution:

     

    DG4, 5 RUG to Individual

     

    1. Set dip switches on board to: 1 on the rest off
    2. Set dip switches on display to:
      1. 5 on the rest off for DG4
      2. 1 and 5 on the rest off for DG5
    3. Disconnect the RUG wire (T-Connecter)
    4. Hold down the top-left three buttons for about 10 seconds
      1. DG4 Non CM Units (left, right, and up arrows)
      2. DB4 CM units (Override, Status, and Config. buttons)
      3. DG5 (Temp., Humid., and Run Hours)
    5. Terminal Adr.
      1. Should be 16 for DG4
      2. Should be 17 for DG5
    6. Set I/O board Adr. to 1
    7. Enter
    8. Enter
    9. Set Trm1
      1. to 16 and Pr for DG4
      2. to 17 and Pr for DG5
    10. Set all other Trm# to none
    11. Scroll to Ok? with the enter key and change it to Yes then hit enter.
     

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance