Discover our Clipsal Smart Home packages as seen on The Block 2018

in location


I'm looking for

  • Wholesalers
    • Uncheck All Check All
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    How do I setup motion detection for the Pelco cameras when integrating it with version 3 Netbotz?


    Netbotz 455, Netbotz 550, and NetBotz 570  are able to support Pelco IP cameras using the Rack Access PX-HID & Pod Sharing functionality. 

    To setup motion detection for the Pelco cameras,  please open Advanced View UI and follow the below steps:

    1. Go to Configuration / Shared Cameras / Sensors / Camera Motion, choose ""Motion Detected"" as Alert State and check ""Enabled"".   (This is set up for all types of cameras.)
    2. Goto Configuration / Shared Cameras / Masking,  enable camera motion here.  Please also make sure to click the ""apply motion mask changes"" button to apply the configuration.

    Please note that Pelco camera motion can be detected once in a 30 second window of time and each instance of motion will continue for that 30 seconds. This is a hard coded limit from Pelco

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance