Discover our Clipsal Smart Home packages as seen on the Block

in location

OR

I'm looking for

  • Wholesalers
    • Uncheck All Check All
  • EXPERTISE
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All
OR

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    What should be checked if an Altivar 61 or 71 display is showing NLP?

    Issue:
    What should be checked if an Altivar 61 or 71 display is showing NLP?

    Product Line:
    ATV61/71 drives

    Environment:
    All

    Cause:
    Drive displays 'NLP'

    Resolution:
    NLP indicates that no line power is present on the L1, L2 & L3 input terminals of the drive controller.

    Check voltage at the L1, L2 & L3 terminals.
    Check for open circuits on line contactors, circuit breakers, disconnect switches, or fuses.

    If NLP state does not change with correct voltage present on L1, L2, & L3, remove the control board and check for loose connections of ribbon cables inside the drive.
    WARNING: This step should be performed while the drive is powered down, and proper personal protective equipment should be worn. 

    For example: In an ATV71HC25N4 a customer found a loose X3 connector from the control board to the board behind and above the control board. This connector was on a ribbon cable that was about 1 inch by 1 inch. Drive ran OK after this was reseated.

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance