in location

OR

I'm looking for

  • Wholesalers
    • Uncheck All Check All
  • EXPERTISE
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All
OR

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Powerhouse Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    With an Econo-flex® drive, when adding the 0-10 Vdc to 4-20 mAdc Converter Kit 31158-297-50, how should it be connected?

    Place the kit into the control terminals on the control board so that the +24 terminal on the kit connects to the +24 terminal in the control board. (On drives with control board versions 5.1 and greater, this will cause the AO1 connection to be empty.)
    The wires that were on the terminal strip should be placed into the same positions with the exception of the wire that was in AI2. This wire can be left disconnected and placed in a condition that will not cause it to accidentally touch any metal parts or terminals.
    Connect the 0-10 VDC control signal to AI2A and AI2B with AI2A as the positive terminal and AI2B as the negative terminal.

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance