Discover our Clipsal Smart Home packages as seen on the Block

in location

OR

I'm looking for

  • Wholesalers
    • Uncheck All Check All
  • EXPERTISE
    • Expand
    • Expand
    • Expand
    • Uncheck All Check All
  • Switchboard Manufacturers
    • Uncheck All Check All
OR

The best way to see what Clipsal electric products can do for your home is seeing them in action at a Clipsal Display Centre.

Product stock may vary according to location. If you're after a specific product range, please check with your chosen location before visiting.

10 Results
    Load More Load Complete
    Change Location

    What terminations do I use to wire a shunt trip to a Masterpact NW circuit breaker for remote operation?

    Product Line:
    Circuit Breakers

    Environment:
    Electrical Distribution Equipment

    Resolution:
    The connector is MX1. For the standard shunt trip use C1 as the common and install a switch in series with C2 for the power.

    For electrical operation of the communicating shunt trip use C1 as the common and install a switch in series with C2 for the power. Also, put maintained power on C3.

    For modbus control of the communicating shunt trip use C1 as the common and supply maintained power on C3.  Plug the BCM harness into the shunt trip and operate with comms.
     

    Didn’t find what you were looking for?

    Try Searching Again View Our Categories

    Need further assistance?

    Our Customer Care department provides total customer service solutions for our residential, industrial and commercial applications.

    Get Assistance